> ## Documentation Index
> Fetch the complete documentation index at: https://custom-dirt-bike-graphics.mintlify.site/llms.txt
> Use this file to discover all available pages before exploring further.

# Installing your graphics

> Seven steps to install dirt bike graphics with no bubbles or lifting edges.

Once your kit is printed, installing it well matters as much as the design. The short version:

**1. Take the plastics off**

Graphics go on far more easily with the plastics off the bike and laid flat.

**2. Remove the old kit and residue**

Peel the old graphics and clear any adhesive left behind.

**3. Clean with isopropyl alcohol**

Wipe every panel so no dirt, wax or grease is left under the vinyl.

**4. Warm the room and the plastics**

Cold plastics are the most common reason graphics lift at the edges.

**5. Dry fit and tape a hinge**

Line each graphic up with the backing still on, and tape one edge as a hinge.

**6. Apply from the center out**

Work from the middle toward the edges to push air out instead of trapping it.

**7. Heat, trim and let it cure**

Use gentle heat on curves, trim the edges, and let the kit cure before you ride or wash the bike.

The full guide covers removal, temperature, curves, bubbles, cure time and common questions: [how to install dirt bike graphics](https://customdirtbikegraphics.com/blog/how-to-install-dirt-bike-graphics).


This documentation is built and hosted on [Mintlify](https://mintlify.com), a developer documentation platform.