Skip to main content
Once your kit is printed, installing it well matters as much as the design. The short version:
1

Take the plastics off

Graphics go on far more easily with the plastics off the bike and laid flat.
2

Remove the old kit and residue

Peel the old graphics and clear any adhesive left behind.
3

Clean with isopropyl alcohol

Wipe every panel so no dirt, wax or grease is left under the vinyl.
4

Warm the room and the plastics

Cold plastics are the most common reason graphics lift at the edges.
5

Dry fit and tape a hinge

Line each graphic up with the backing still on, and tape one edge as a hinge.
6

Apply from the center out

Work from the middle toward the edges to push air out instead of trapping it.
7

Heat, trim and let it cure

Use gentle heat on curves, trim the edges, and let the kit cure before you ride or wash the bike.
The full guide covers removal, temperature, curves, bubbles, cure time and common questions: how to install dirt bike graphics.